Altec Lansing 1415A - Monaural Power Amplifier (ca. 1988)
ausserordentlich Last-stabile und flexibel einsetzbare Endstufe aus dem Profi-Bereich.
POWER made in Oklahoma, USA!
Ursprünglich für professionelle Beschallungen von Kinos und Events entwickelt, ist sie vor allem auch bei Band beliebt und entsprechend gesucht. Treibt aber ebenso leistungshungrige, lastkritische Lautsprecher wie Infinitiv Kappa, JBL, Klipsch, EV und natürlich Altec.
Toller, kerniger Klang.
Zuletzt verwendet vor ca. 2 Jahren in einer Heimkino-Installation.
Zustand
- gebraucht
- technisch und optisch guter Zustand
- leichte Spuren an einer der Fronten
- beide Gehäuse (nicht die Fronten) wurden professionell neu lackiert
Das Flight-Case ist nicht Teil der Auktion, kann aber bei Interesse mit dazu erworben werden.
Bei Sofort-Kauf gibt es das Flight-Case GRATIS mit dazu.
Es handelt sich um 2 Stück der 1415A - der Preis gilt für beide zusammen.
Nur Abholung - kein Versand.
Original Beschreibung von Altec Lansing:
Amplifier / Load Protection: Short circuited loads, Excessive load reactance , Excessive temperature
Monaural Power Amplifier (1988)
- Specifications
- Power output: 150 watts into 8Ω (mono)
- Frequency response: 10Hz to 30kHz
- Total harmonic distortion: 0.1%
- Damping factor: 50
- Input sensitivity: 0.775V
- Signal to noise ratio: 100dB
- Speaker load impedance: 4Ω (minimum)
- Dimensions: 133 x 482 x 317mm
- Weight: 14kg
- Finish: black
- Year: 1988
DESCRIPTION The Altec Lansing 1415A power amplifiers are high quality low cost monaural power amplifiers for general purpose applications and those involving the use of ALTEC LANSING'S 1700 series mixer products.Both amplifier models are identical in size and features and differ only in their output power ratings. The 1415A produces 150 watts of continuous average output power. Included are many built-in features that far exceed what is normally found in amplifiers of this type. This fact undeniably eases any design chore. For example, the amplifiers include a 15 kiZ input bridging transformer, a 300 Hz high pass filter (switchable), a 15 dB input pad (switchable), and a choice of four input connector types; a 5-lug screw terminal, female XLR, male XLR, and a phono connector. The male XLR is also usable as a convenient patch output point for routing the input signal to another amplifier.Two auxiliary unbalanced outputs are also provided. One is before (pre-fader), and the other after (post-fader), the MASTER output level control. These outputs greatly simplify many complex system designs. In addition to a 40 direct output, a built-in output transformer provides a plurality of true balanced outputs including 80 , 25 volts, and 70.7 volts.The amplifiers are fully protected from short circuited loads, over temperature, and excessive load reactance, and the loads from turn-on/turn-off transients, subsonic signals, and DC. When a problem is detected the output relay automatically disconnects the load and illuminates the front panel PROTECT indicator. In addition, a front panel clipping indicator warns of excessive output levels. The MASTER level control and configuration switches are rear mounted for extra protection against "accidental" changes made by non-qualified personnel.The Altec Lansing 1415A power amplifiers are the choice in professional designs where quality, reliability, flexibility, and cost are of prime concern.
)
)
-ovp)
-ampli-professionnel)
